A Great Little Fan Sep 16, 2016

I bought this in-line fan to pump warm air into a chase containing hot and cold water pipes. When outdoor temperatures drop below 15 degrees Fahrenheit, the air in the chase falls below freezing, so I was worried that the pipes would freeze. This little fan together with flex duct (I stripped away the outer insulation) solved the problem. I have a thermostat in the chase and a control system that turns on the fan when the chase temperature drops below 40 degrees F. Now I can spend time... more

So Far So Good Nov 04, 2016

Your illustrations for installation should be better. For example the rerouting of the condensation lines was not illustrated well. We figured it out but it took extra time. ....time is...? EVERYTHING!

Nice Panel Radiator Jul 19, 2016

I just wish it was more simple to figure out which connectors were needed. The description should be simpler. All I wanted was 1/2" copper connections but somehow the unit showed up with PEX connections. Overall good radiator though.

Crown Boiler Awr105 - 87k Btu - 83.7% Afue - Hot Water Propane Boiler - Chimney Vent Review Aug 17, 2016

Installed this boiler in June 2012 - Very good documentation - Very good response from customer service when I had a question about the controls. Checked on higher efficiency rated boilers but could not justify the much higher price. Until you make up the increase in price with the savings in fuel the unit would be 8 - 10 years old. By then you would probably have maintenance problems and just check the prices on parts for the higher efficiency boilers (parts prices are very high compared... more

Warmwire Heated Floor Jun 03, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more